Bluetooth Operations For Kw-Adv793; Connecting Bluetooth Devices - JVC KW-AVX838 Instructions Manual

Menu item
Ring Mode
Ring Tone Change
Initialize
Information

Bluetooth operations for KW-ADV793

For Bluetooth operations, it is required to connect the
Bluetooth Adapter (KS-BTA200: separately purchased)
to the expansion port on the rear.
• Refer also to the instructions supplied with the
Bluetooth Adapter and the Bluetooth device.
• Refer to pages iii and iv at the end of manual to
check the countries where may use the Bluetooth®
function.
To use a Bluetooth device through the unit ("BT
Phone" and "BT Audio") for the first time, you need
to establish Bluetooth wireless connection between
the unit and the device.
• Once the connection is established, it is registered in
the unit even if you reset your unit. Up to 5 devices
can be registered in total.
• Only one device can be connected at a time for each
source ("BT Phone" and "BT Audio").
Selectable setting/item
In Unit
z
: Selects the ring tone set on the unit.
z
In Phone : Selects the ring tone set on the mobile phone. (This
function may not work depending on the mobile
phone.)
When <Ring Mode> is set to <In Unit>, you can select the ring tone for
received calls and Text message from Tone1, Tone2, Tone3.
z
Call Tone : Selects the ring tone for phone calls.
z
Message Tone : Selects the ring tone for Text message.
Hold [Enter] to initialize all settings you have made in <Bluetooth>
menu.
The following information is shown:
z
Name : The unit name
z
Address : The Mac address of the unit
z
Version : The Bluetooth software
z
Phone Device/ : The connected device names
Audio Device

Connecting Bluetooth devices

Connecting a new Bluetooth
device
Registration (Pairing) methods
Use either of the following items in <Bluetooth>
menu to register and establish the connection with a
device.
• Select "BT Phone" or "BT Audio" as the source to
operate <Bluetooth> menu. (
Open
Search
45
Initial: Underlined
KW-ADV793
10)
Make the unit ready to establish a new
Bluetooth connection. The connection
is established by operating the
Bluetooth device.
Make the unit ready to establish a new
Bluetooth connection. The connection
is established by operating this unit.
Continued on the next page