HP Compaq 6715b Maintenance And Service Manual page 104

4. Remove the following screws:
(1) Two Phillips PM2.5×5.0 screws that secure the system board and PC Card/audio board
assembly
(2) One Phillips PM2.5×5.0 screw that secures the system board
(3) Two Phillips PM2.5×5.0 screws that secure the optical drive connector board
(4) Two Phillips PM2.5×3.0 screws that secure the system board
NOTE:
(5) that secures the SIM slot board must be removed.
5. Use the right side of the system board (1) immediately behind the optical drive connector to lift the
right side of the system board (2) until the rear left corner of the system board (3) clears the base
enclosure.
6. Remove the system board (4) by pulling it away from the top cover at an angle until it clears the
top cover.
94 Chapter 4 Removal and replacement procedures
If the computer is equipped with a WWAN module, another Phillips PM2.5×5.0 screw