Generator Shut-Down Procedure - MULTIQUIP Power WHISPERWATT DCA-45SSIU2 Parts And Operation Manual

NORMAL SHUT-DOWN
To shutdown the generator, use the following procedure:
1. Switch the MAIN, AUX and GFCI circuit breakers
(Figure 61) to the "OFF" position (no load).
Figure 61. Main, AUX. and GFCI
Circuit Breakers (OFF)
2. Push the engine throttle control lever inward (Figure 62)
to the " LOW " position.
Figure 62. Engine Throttle Control Lever (Low)
3. Let the engine cool by running it for 3-5 minutes with no
load applied (circuit breakers in the off position).
4. Place the ignition switch (Figure 63) in the "STOP" position,
remove the key and store in a safe place.
Figure 63. Ignition Switch (Off Position)
5. Remove all loads from the generator.
PAGE 44 — DCA-45SSIU2 — OPERATION AND PARTS MANUAL (STD) — REV. #7 (06/13/07)
DCA-45SSIU2 — GENERATOR SHUT-DOWN PROCEDURE
EMERGENCY SHUT-DOWN
1. To shut-down the engine in the event of an emergency,
switch the MAIN , GFCI and LOAD (Figure 61) circuit
breakers to "OFF" position.
2. Turn the ignition switch key to the "STOP" position.
SHUTDOWN