Cub Cadet GT 2550 Operator's Manual page 30

FUEL FILTER
WARNING: Do not replace the fuel filter
when engine is hot.
The engine is equipped with an inline fuel filter.
Visually inspect the filter periodically for a build-up of
residue inside the filter body, and for a dirty element
which can be indicated by discoloration. Replace the
fuel filter when dirty.
HEADLIGHTS
Refer to SPECIFICATIONS when replacement of
head lamp bulbs is necessary.
Replace headlight bulbs as follows: (See Figure 25)
1. Fully raise the hood of the tractor.
2. Unplug the wire harness leads from the headlight
socket terminals. Note which wire connects to
each terminal before disconnecting.
3. Rotate the socket assembly approximately 1/4 turn
to align the socket tab with the reflector housing
notch; then withdraw the bulb and socket
assembly from the reflector housing.
4. Push the bulb inward and turn counterclockwise to
remove from the socket.
SOCKET TAB
REFLECTOR
NOTCH
Figure 25
5. Align a locking post of the bulb base with the notch
in the socket, then push the bulb inward and turn
clockwise to lock
6. Align the socket tab with the notch of the reflector
housing; then push the socket inward and turn as
necessary to lock the socket in the housing:
7. Connect the wire harness leads to the appropriate
socket terminals.
FUSES
Always use the same capacity fuse for replacement.
Refer to SPECIFICATIONS. If the electrical system
does not function, check the fuses.
To replace a fuse, pull the old fuse from the fuse holder
and install the new fuse.
GENERAL BATTERY INFORMATION
ALWAYS SHIELD EYES AND PROTECT SKIN AND
CLOTHING WHEN WORKING NEAR BATTERIES.
TERMINAL
SOCKET
REFLECTOR
HOUSING MAINTENANCE OF BATTERY
The tractor is shipped with a wet battery — the battery
acid has already been added and the battery sealed.
Although the battery is maintenance free, the following
care should be taken when handling the battery and to
assure its proper life cycle.
1. Spray the terminals and exposed wire with a
2. Always keep the battery cables and terminals
3. Always keep the terminal covers in place over the
4. Avoid tipping. Even a sealed battery will leak
30
WARNING
a. Battery posts,
accessories contain
compounds. Wash Hands after handling.
b. Should battery acid accidentally splatter into
the eyes or onto the skin, rinse the affected
area immediately with clean cold water. If
there is any further discomfort, seek prompt
medical attention.
c. If acid spills on clothing, first dilute it with clean
water, then neutralize with a solution of
ammonia/water or baking soda/water.
d. NEVER connect (or disconnect) battery
charger clips to the battery while the charger is
turned on, as it can cause sparks.
e. Keep all sources of ignition (cigarettes,
matches, lighters) away from the battery. The
hydrogen gas generated during charging can
be combustible.
f. As a further precaution, only charge the
battery in a well ventilated area.
DANGER
BATTERIES CONTAIN SULFURIC ACID AND
MAY EMIT EXPLOSIVE
EXTREME CAUTION
BATTERIES. KEEP BATTERIES OUT OF THE
REACH OF CHILDREN.
battery terminal sealer, or coat the terminals with a
thin coat of grease or petroleum jelly, to protect
against corrosion.
clean and free of corrosion.
battery terminals.
electrolyte when tipped.
terminals and related
lead and lead
GASES. USE
WHEN HANDLING