Cub Cadet GT 2550 Operator's Manual page 12

M. LIFT HEIGHT INDICATOR
The lift height indicator is located in the left fender and
indicates the height of the deck attachment when in-
stalled.
N. SEAT ADJUSTMENT LEVER
The seat adjustment lever (See Figure 6) is used to
move the seat forward or rearward into one of five po-
sitions. See ADJUSTING THE SEAT in Section III.
12V POWER
OUTLET
Figure 6
O. 12V POWER OUTLET
The 12V power outlet ( see Figure 6) is located on the
front/right surface of the fender, below the seat. It is
used for the convenience of plugging in accessories
that require a power source with a maximum load of 5
amps at 12 volts.
O. TRANSMISSION RELEASE LEVER
The transmission release lever is located at the back of
the tractor in the rear drawbar. When engaged, this le-
ver opens a hydrostatic pump bypass valve, which al-
lows the tractor to be pushed short distances by hand.
To engage the release lever, lift and pull the lever rear-
ward through the keyhole until the flange on the rod is
outside the drawbar. Lower the lever into the slot and
release. To disengage the release lever, pull back on
the lever, lift out of the slot and release.
P. FUSES
The two fuses are located under the hood behind the
dash panel. Fuses are installed to protect the tractor's
electrical circuitry and components from damage
caused by excessive amperage.
Q. SAFETY INTERLOCK SWITCHES
This tractor is equipped with a safety interlock system
for the protection of the operator. If the interlock sys-
tem should ever malfunction, do not operate the trac-
tor. Contact your authorized Cub Cadet Dealer. The
safety interlock system prevents the engine from
cranking or starting unless the brake pedal is fully de-
pressed, and the PTO switch is in the "OFF" position.
The safety interlock system will automatically shut off
the engine if the operator leaves the seat before en-
gaging the brake lock.
The safety interlock system will automatically shut off
the engine if the operator leaves the seat with the PTO
in the "RUN" position, regardless of whether the brake
lock is engaged. The PTO switch must be moved to the
"OFF" position to restart the engine.
With key switch in "NORMAL MOWING" position:
The safety interlock system will automatically shut off
the PTO if the reverse control pedal is depressed with
the PTO in the "RUN" position. To re-engage the PTO,
release the reverse control pedal, move the PTO
switch to the "OFF" position, then again pull the switch
to the "RUN" position.
FUEL TANK
The fuel tank is located under the rear fender. The filler
cap is in the center/rear of the fender (See Figure 7).
12
Figure 7