Sanyo XHX1252 Instruction Manual page 6

K: Time setting buttons
L: SET button
M: CL button
N: VENTILATION button
O: Remote control sensor
P: ACL button (ALL CLEAR)
Q: Slide switch
NOTE
6
Parts Name and Functions (continued)
: Press this button to increase the time.
: Press this button to decrease the time.
Use this button to set the timer.
Use this button to clear the timer setting.
This is used when a ventilation fan (available commercially) is connected. Pressing the
VENTILATION button turns the fan on and off. The ventilation fan also turns on and off when
the air conditioner unit is turned on and off. (The display of the remote control unit shows
" " while the ventilation fan is running.)
* If the VENTILATION button is held down for 4 or more seconds when the batteries have
been replaced, " " appears on the display, and the ventilation fan can be used.
This detects the temperature around the remote control unit when the remote control unit
position has been selected using the sensor button.
Puts the wireless remote control unit into pre-operation status. This is used after the batteries
have been replaced or when the slide switch setting has been changed.
This switch is for setting the operation mode of the indoor unit and setting the flaps.
• The wireless remote control unit sends the temperature signal to the air conditioner
regularly at five-minute intervals. If the signal from the wireless remote control unit stops
for more than ten minutes due to the loss of the wireless remote control unit or other
trouble, the air conditioner will switch to the temperature sensor which is built into the
indoor unit and control the room temperature. In these cases, the temperature around the
wireless remote control unit may differ from the temperature detected at the air
conditioner's position.
• When low fan speed is selected and the air conditioner is in cooling operation at a low
outdoor temperature of less than 50°F, the air conditioner may automatically switch to
medium fan speed to prevent freezing.
OI-837-6-EG