Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kohler Purist K-1191-L
Summary of Contents for Kohler Purist K-1191-L
- Page 1 Installation Guide Purist™ Effervescent Bath K-1191-L, K-1191-R, K-1191-LC, K-1191-RC M product numbers are for Mexico (i.e. K-12345M) Los números de productos seguidos de M corresponden a México (e.j. K-12345M) Français, page “Français-1” Español, pagina “Español-1” 1012493-2-A...
-
Page 2: Important Information
Do not relocate the pump, or make other modifications to the overflowing bath system, as this could adversely affect the performance and safe operation. Kohler Co. shall not be liable under its warranty or otherwise for personal injury or damage caused by any such unauthorized modification. -
Page 3: Table Of Contents
Thank You For Choosing Kohler Company ........ -
Page 4: Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before you start installation. If you encounter any installation or performance problems, please don’t hesitate to contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler Company. -
Page 5: List Of New Terms
Overflow channel-The overflow water collection channel at the drain end. Plastic suction cover-The plastic guard attached over the water intake port located in the bathing well. The suction cover must always be installed during product use to ensure user safety. Kohler Co. 1012493-2-A... -
Page 6: Roughing In Information
An access panel is required. The recommended dimensions for this access panel are 40” (101.6cm) W x 15” (38.1cm) H. Refer to the roughing-in diagram for suggested access panel location. Make sure the flooring is in good condition, and offers adequate support for your bath. 1012493-2-A Kohler Co. -
Page 7: Roughing In Information
1 (2.5cm) air gap above the outer rim of the unit. NOTE: The listed Kohler spouts are designed to work with this bath at the listed location. There may be additional spouts that are not listed. -
Page 8: Position The Unit
Make sure all supply connections are tightened securely. Open the hot and cold water supplies, and check the supply connections for leakage. Run water into the bathing well, and check the drain connections for leakage. 1012493-2-A Kohler Co. -
Page 9: Make The Electrical Connections
With the unit running, check all harness (piping) connections for leaks. Visually observe the effervescence rising to the surface of the water. Kohler Co. 1012493-2-A... - Page 10 Check the harness connections for leakage one more time. Press the On/Off control switch again to turn off the unit. The switch will also turn off. NOTE: For additional information on operation of your overflowing bath, see “Using Your Bath” section. 1012493-2-A Kohler Co.
-
Page 11: Complete The Finished Wall Or Deck
Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild abrasive action to any residual plaster. Kohler Co. 1012493-2-A... -
Page 12: Using Your Bath
Press the “On/Off” control switch again to turn off the bath. The “On/Off” control switch will turn off to indicate the end of the operating mode. NOTE: A built-in timer automatically stops the bath after approximately 20 minutes of operation. 1012493-2-A Kohler Co. -
Page 13: Chromatherapy Light Operation
When restarting the pump the submerged chromatherapy lights will turn back on. The chromatherapy lights may be turned on when the pump is off. Turning on the pump when the lights are operating will not affect the lights. Kohler Co. 1012493-2-A... - Page 14 1012493-2- Kohler Co.
- Page 15 Kohler Co. 1012493-2-...
- Page 16 USA: 1-800-4-KOHLER México: 001-877-680-1310 Canada: 1-800-964-5590 kohler.com ©2002 Kohler Co. 1012493-2-A...