Resetting The System; Using The Language Code List - Pioneer DCS-585 Operating Instructions Manual

14 Additional information
Message
OC ERR 1
OC ERR 2
OVER TEMP
BT ERR
TV AUDIO
CANNOT
TRAYLOCK
KEYLOCK
PHONESIN
HDMI ERR
USB ERR
EEP ERR
EXIT

Resetting the system

Use the front panel controls to reset all system
settings to the factory default.
1 With the system on, press SHIFT+SETUP.
Use / to select INITIAL then press
2
ENTER.
Use / to select ALL INIT then press
3
ENTER.
• INIT OK is displayed.
4 Press ENTER while INIT OK is blinking.
Note
1 Do not operate the unit without reason or pull the power cord because the system's power automatically turns on.
60
En
Description
• Check whether the speaker cables are short-circuited. If the error message
continues to be displayed, contact your Pioneer authorized service center or your
dealer for servicing.
• Try lowering the volume. If this problem is not fixed by removing and inserting the
power cable, this unit may be damaged. In such an event, please contact a Pioneer-
authorized service center or your nearest dealer.
• Power consumption by Bluetooth ADAPTER is too high to supply the power.
Reconnect the Bluetooth ADAPTER.
• Indicator is lit for two seconds if the listening mode is changed while HDMI audio
mode is set for TV.
• Operation is prohibited because DVD/CD or USB isn't selected.
• Appears when DVD/CD is not selected and SHIFT+USB REC is pressed.
• The tray lock is on. See General in Troubleshooting on page 56.
• The key lock is enabled. See Setting the sleep timer on page 50.
• An operation is prohibited because the headphones are connected.
• See HDMI connection above for troubleshooting tips. See also Resetting the
HDMI connection on page 44 if the problem persists.
• See Important in Using the USB interface on page 32 for more on this.
• Contact your Pioneer authorized service center or your dealer for servicing.
• Appears when any prohibited signal is input or the headphones are connected
while the menu screen is displayed, and then the display returns to the normal
display.
1

Using the language code list

Some of the language options (see Language
settings on page 39) allow you to set your
preferred language from any of the 136
languages in the Language code list below.
1 Select 'Other Language'.
Use / to select either a code letter or
2
a code number.
Use / to select a code letter or a code
3
number.
See the Language code list below for a
complete list of languages and codes.