Connecting The Cord - Pioneer DCS-424K Operating Instructions Manual

3 Fix the base to the lower cabinet from
the underside, using the four screws
(M4 x 16).
4 Insert the upper cabinet to the lower
cabinet.
5 Fix the upper cabinet and the lower
cabinet from the backside of the
speaker using the two screws (M4 x
12).
CAUTION
• Be careful not to tighten screws excessively.
If excessive force is used to tighten screws,
the threads of screw and/or nut may be
damaged. Use a middle-sized manual
screwdriver during assembly. Do not use
power screwdrivers or oversized screwdrivers
that may exert excessive force on the screws
and nuts. Confirm that no foreign matter is
stuck to the base or the lower cabinet during
assembly. If the unit is assembled with
foreign matter stuck between the base and
lower cabinet, the unit may not be assembled
securely, resulting in tipping or falling.
• Do not stand on the speaker stand base
of the tall speaker to push or swing the
speaker. The speaker may fall and break,
or someone may be injured. Pay special
attention to children.

Connecting the cord

1. Attach one end of the supplied speaker
cord to the rear of the each speaker.
Connect the wire with the colored
marker to the red (+) terminal; the plain
wire to the black (–) terminal. Press
down the spring-loaded tab and insert
the wire, as shown below. Release the
tab to secure the wire.
Red (+)
Black (–)
Installation
Red colored marker
17
3