Maintenance; Crossover Ignition System Operations - Weber Platinum I 3400 LP Operating Manual

MAINTENANCE

h) Lift and twist the burner assembly slightly, to separate the
crossover tube from the burners. Figure 13. Remove the
burners from the cooking box.
Crossover tube
i) To reinstall the burners, reverse steps c) through h).
CAUTION: The burner openings must be positioned
properly over the valve orifices. Figure 14 (a).
Check proper assembly before fastening manifold in
place. Figure 14 (b).
(a)
Valve
Burner
(b)
Figure 13
Figure 14
j) Reinstall the Spider Stopper Guards. Slightly rotate the
Spider Stopper Guards so that the seams are in line with
the Venturi fins. There should be no gaps in the seams or
in the fit around the burners and valves. Figure 15.
Venturi fin
CAUTION: If the Spider Stopper Guards do not fit
tightly, contact Weber-Stephen Customer Service.
CAUTION: After reinstalling the gas lines, they
should be leak checked with a soap and water
solution before using the barbecue.

Crossover Ignition System Operations

If the Crossover Ignition System fails to ignite the Front
burner, light the Front burner with a match. If the Front
burner lights with a match, then check the Crossover
Ignition System.
Check that both the white and black ignition wires are
attached properly. Figure 16.
Check that the Crossover Ignition button pushes the
igniter (button) down, and returns to the up position.
Check to see if the igniter is loose in the frame. Tighten if
necessary; See "Check That Items Are Secured" in the
Step-By-Step Guide for correct procedure.
If the Crossover Ignition System still fails to light, contact
Weber-Stephen Customer Service.
White wire
Black wire
13
Check fit
around valve
Check fit around burner
Figure 15
Figure 16