Advertisement
1. F.G.: Ground the P-794H by connecting a grounded wire to the F.G.
(Frame Ground) of the P-794H.
2. DSL: If you are using the P-794H with Internet access, use a
telephone wire to connect one of the DSL ports to the telephone wall
jack for Internet access.
If you are using the P-794H for point-to-point connection in CO/CPE
mode, use telephone wires to connect one or both (for maximum
speed) DSL ports to the other DSL port(s) of another P-794H.
Refer to page
9
and the Tutorials chapter in User's Guide for more
information about the P-794H operating in CO/CPE mode.
3. LAN: Use an Ethernet cable to connect a computer to one of these
ports for initial configuration. If you are operating in CO mode,
connect the LAN port to a router for Internet access.
4. CID: If you want to configure the P-794H by CLI command, use a
console cable to connect the CID port to your computer's COM port.
This is for service technicians only.
5. AC Power: Use the power adaptor provided to connect an
appropriate power source to this socket.
Make sure the Reset switch is pointing up before powering
up the P-794H. Do not push the switch down unless you
want to reset the P-794H to the factory default settings.
4
Advertisement
