Packet Data Access Points; Wlan Internet Access Points - Nokia N95 User Manual

Connection name
●
the connection.
Data bearer — Select the data connection type.
●
Depending on the data connection you select, only
certain setting fields are available. Fill in all fields
marked with Must be defined
Other fields can be left empty, unless you have been
instructed otherwise by your service provider.
To be able to use a data connection, your service
provider must support this feature, and if necessary,
activate it for your SIM card.

Packet data access points

Press , and select
Connection Access points
>
New access point.
Follow the instructions from your service provider.
Access point name
●
name from your service provider.
User name — The user name may be needed to
●
make a data connection, and is usually provided by
the service provider.
Prompt password
●
password every time you log in to a server, or if you
do not want to save your password in the device,
select Yes.
Password — A password may be needed to make
●
a data connection and is usually provided by the
100
service provider.
— Enter a descriptive name for
or with a red asterisk.
Tools Settings
> >
Options
> >
— You obtain the access point
— If you must enter the
Authentication
●
your password encrypted or
password encrypted when possible.
Homepage
●
are setting up, enter the web address or the address
of the multimedia messaging centre.
Select Options
following settings:
Network type
●
to transfer data to and from your device. The other
settings depend on the selected network type.
Phone IP address
●
address of your device.
DNS address
●
Edit or primary and secondary DNS servers, if required by
your service provider. Contact your internet service
provider to obtain these addresses.
Proxy server address
●
proxy server.
Proxy port number
●
the proxy server.

WLAN internet access points

Press , and select
Connection
New access
Follow the instructions from the WLAN service
provider.
— Select Secure
Normal
— Depending on the access point you
Advanced settings
>
— Select the internet protocol type
(for IPV4 only) — Enter the IP
— Enter the IP addresses of the
— Enter the address of the
— Enter the port number of
Tools Settings
>
Access points Options
> >
point.
to always send
to send your
to change the
>
Edit or
>