Atapi Cd-Rom Drives; Exit Menu; Atapi Cd-Rom Drives Submenu - Intel D845HV Product Manual

Intel Desktop Boards D845HV and D845WN Product Guide

ATAPI CD-ROM Drives

Maintenance
The submenu shown in Table 27 is for setting ATAPI CD-ROM drives.
Table 27.

ATAPI CD-ROM Drives Submenu

Feature
st
1 ATAPI CD-ROM Drive
(Note)
Note: This boot device submenu appears only if at least one boot device of this type is installed. This list will display
up to four ATAPI CD-ROM drives, the maximum number of ATAPI CD-ROM drives supported by the BIOS.

Exit Menu

Maintenance
The menu shown in Table 28 is used to exit the BIOS Setup program, saving changes, and loading
and saving defaults.
Table 28.

Exit Menu

Feature
Exit Saving Changes
Exit Discarding Changes Exits without saving any changes made in the BIOS Setup program.
Load Setup Defaults
Load Custom Defaults
Save Custom Defaults
Discard Changes
66
Main Advanced
Options
Dependent on installed
ATAPI CD-ROM drives
Main Advanced
Description
Exits and saves the changes in CMOS SRAM.
Loads the factory default values for all the Setup options.
Loads the custom defaults for Setup options.
Saves the current values as custom defaults. Normally, the BIOS reads the
Setup values from flash memory. If this memory is corrupted, the BIOS reads the
custom defaults. If no custom defaults are set, the BIOS reads the factory
defaults.
Discards changes without exiting Setup. The option values present when the
computer was turned on are used.
Security Power
Description
Specifies the boot sequence from the available
ATAPI CD-ROM drives. To specify boot sequence:
1. Select the boot device with < > or < >.
2. Press <Enter> to set the selection as the
intended boot device.
Security Power
Boot Exit
Boot Device Priority
Hard Disk Drives
Removable Devices
ATAPI CD-ROM Drives
Boot
Exit