GE S2100 Owner's Manual page 20

Before you call for service...
WATER (cont.)
Water spraying during
spin cycle
Washer did not fill
to chosen level
(PerfecTemp Plus
and START lights
are flashing)
Water fills and drains
at the same time
NOISE
Washer is noisy
OTHER
Labels on the exterior
of the washer will not
peel off cleanly
20
Possible Causes
Washer in spin cycle
Extremely low water pressure
Inlet hoses are kinked
Water valve screens are
stopped up
Drain stand pipe is too low
Possible Causes
Washer is uneven
Washer load is
unbalanced
Shipping rod is still assembled
in unit
Washer is sitting too close
to wall (causes knocking
during cycle)
PerfecTemp Plus feature
(on some models) is being used
Possible Causes
Occasionally the adhesive
used on the labels does
not release cleanly
What To Do
• Spray rinse during a spin cycle is normal.
• Press the START button again.
• Straighten hoses.
• Turn off the water source and disconnect water fill
hoses from the upper back of the washer. Use a brush
or toothpick to clean the screens in the machine.
Reconnect the hoses and turn the water back on.
• Drain stand pipe must be above 30" (76.2 cm).
What To Do
• To level the front of the washer, adjust the front leveling
legs by rotating the individual leg in the proper direction
for up or down. To level back of washer, lift back of
machine 4" (11 cm) and set down.
• Press START to pause the washer, open the lid and
redistribute the load evenly. Close the lid and press
START again.
• To remove shipping rod from washer, pull yellow tag and
attached rod from the bottom right hand side of washer.
• Pull washer away from the wall; about 4" (11 cm)
is needed.
• This is normal. PerfecTemp Plus (on some models) turns
water valves off and on to adjust water temperature.
What To Do
• Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the surface
of the washer.