Installation Instructions; Install The Pedestal; To The Washer; Level The Washer - GE Profile SmartDispense SPBD880 Owners And Installation Manual

PREPARE THE PEDESTAL

2
Pull the
A Connectors
drawer out
as far as it
will go.
B Remove
the screws
from the
drawer
slides. Detach the wiring connector and the
hose connector at the back of the drawer.
Slide the drawer out of the base and set aside.
Remove the screws from the service panels at
C
the rear of the pedestal and place the panels
within the pedestal.
Remove screws from
service panels

INSTALL THE PEDESTAL

3

TO THE WASHER

Place the pedestal against the bottom
A
of the unit. Check to be sure the drawer front
is at the front of the unit.
B Align the holes in the pedestal with the holes
in the bottom of the unit. Use a Phillips
screwdriver to install the 4 screws through
the front of the pedestal and through the rear
panels and into the unit—do not tighten.
Slide the pedestal toward the unit, until it is
C
aligned front to back. Use an 8 mm socket
wrench to securely tighten the screws.
Replace the service panels on the back
D
and tighten the screws.

Installation Instructions

13

LEVEL THE WASHER

4
Stand the washer upright. Move it close to its
A
final location.
Make sure that the washer is level by placing
B
a spirit level on top. Check side to side and
front to back.
Use an open-ended
C
wrench to adjust
the legs in and out.
Tighten the locknut
against the bottom
of the pedestal.
NOTES:
• To minimize vibration, the locking nuts must
be tight.
• To reduce vibration, ensure that all four
rubber leveling legs are firmly touching
the floor. Push and pull on the back right
and then back left of your washer.

REINSTALL THE DRAWER

5
Check to be
A
sure the slides Connectors
are closed.
B Slide the
drawer into
the opening.
Align the
drawer
supports to
the slides on each side.
Open the drawer fully. Reattach the hose
C
connector and wiring connector at the rear
of the drawer. Make sure both connections
are secure.
D Reinstall the original screws into each drawer
slide. Tighten both screws. The drawer should
slide smoothly when you push it closed.

REMOVE SHIPPING SCREWS

6
Remove the 4 shipping screws, plastic support
tubes and rubber grommets on the back side
of the washer.