Panasonic Studio System 300 Installation Manual page 24

Panasonic Solutions Company
Section 2 – Cable Identification
Optional – AJA P-Tap Power Cable
This cable Provides 12 Volt DC Power
for Optional AJA Fido TR Fiber Device
or for an AJA DA.
Example: AG-HPX500 has only 1 SDI out. This
camera will need the AJA DA to provide additional
SDI outputs. One for the AG-CA300 and the
other to feed the On Board Monitor. If this
example configuration is used, it will also require
the Multi Tap to provide the additional accessories
power needs. In this case, the On Board Monitor
and the AJA DA. Note: The BT-CS910G cable is
not recommended for the AG-HPX500.
If Using the AJA DA, Please be sure to check the
voltage input range. Some AJA Products only run
on 5 Volts DC.
24