Understanding Auto Eq Error Messages - Pioneer AVH-2450BT Owner's Manual

Additional information
Message Cause
Your device is This unit's DivX
not author- registration code
ized to play
has not been
this DivX pro-
authorized by the
tected video. DivX VOD con-
tents provider.
Format Read Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound.
Video frame DivX file's frame
rate not sup- rate is more than
ported 30 fps.
Audio Format This type of file is
not supported
not supported on
this unit.
iPod
Message Cause
Format Read
Sometimes there
is a delay be-
tween the start of
playback and
when you start to
hear any sound.
Error-02-6X/-
Communication
9X/-DX
failed.
iPod failure.
Error-02-67
The iPod firm-
ware version is
old.
Stop There are no
songs.
There are no
songs in the cur-
rent list.
Action
Register this unit
to the DivX VOD
contents provider.
Wait until the mes-
sage disappears
and you hear
sound.
Select a file that
can be played.
Select a file that
can be played.
Action
Wait until the mes-
sage disappears
and you hear
sound.
Disconnect the
cable from the
iPod. Once the
iPod's main menu
is displayed, recon-
nect the iPod and
reset it.
Disconnect the
cable from the
iPod. Once the
iPod's main menu
is displayed, recon-
nect the iPod and
reset it.
Update the iPod
version.
Transfer songs to
the iPod.
Select a list that
contains songs.
Message Cause
Not Found No related
songs.
Bluetooth
Message Cause
Error-10 The power failed
for the Bluetooth
module of this
unit.
Understanding auto EQ
error messages
When correct measurement of the car's inter-
ior acoustic characteristics is not possible
using auto EQ, an error message may appear
on the display. In such cases, refer to the table
below to see what the problem is and how it
may be corrected. After checking, try again.
Message Cause
Error. Please
The microphone
check MIC.
is not connected.
Error. Please The microphone
check xxxx cannot pick up
speaker. the measuring
tone of a speaker.
Appendix
Action
Transfer songs to
the iPod.
Action
Turn the ignition
switch OFF and
then to ACC or ON.
If the error mes-
sage is still dis-
played after
performing the
above action,
please contact
your dealer or an
authorized Pioneer
Service Station.
Action
Plug the optional
microphone se-
curely into the
jack.
! Confirm that the
speakers are con-
nected correctly.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Plug the micro-
phone securely
into the jack.
97
En