Table of Contents
Advertisement
ME38-ODV-2 Homefire
Operation - Model ME38-ODV-2
ME38-ODV-2
For Your Safety - READ BEFORE LIGHTING:
WARNING:
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone
in your building.
Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
1. STOP! Read the safety information above on this label.
2. Flip down lower trims.
3. Push in gas control knob and turn clockwise
4. Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas, STOP! Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5. Locate pilot burner (See illustration at right.) and follow
steps below.
6. Turn knob on gas control counterclockwise
LOT."
7. Push in gas control knob completely and hold. Light with
Gas Control Knob
(Shown in "Pilot" postion.)
1. Turn off remote switch.
2. Flip down lower trim.
Page 1
with Continuous Pilot
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
Lighting Instructions:
to "OFF."
to "PI-
NOTE: Knob cannot be turned from
"PILOT" to "OFF" unless knob is
pushed in slightly. Do not force.
To Turn Off Gas To Appliance:
If you cannot reach your gas supplier, call the Fire De-
partment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
Piezo Igniter button. Continue to hold the control knob in for
about (1) minute after the pilot is lit. Release the knob and it
will pop back up. Pilot should remain lit. If it goes out repeat
steps 3 through 8.
If knob does not pop up when released. Stop and im-
mediately call your service technician or gas supplier.
If the pilot will not stay
a f t e r
s e v e r -
tries, turn the gas control knob
"OFF" and call your service
technician or gas supplier.
8. Push in gas control knob and turn
counterclockwise
9. Flip up lower trim.
10.Turn on remote switch to ignite fire.
3. Push in gas control knob slightly and turn
to "Off". Do not force.
4. Flip up lower trim.
to "ON."
clockwise
Part No. XG0123
lit
al
to
Advertisement
Table of Contents
