Yamaha Morphous CP250W Owner's Manual page 58

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Right floorboard mat
2. Engine oil filler cap cover
4. Remove the oil filler cap as shown,
with the spark plug wrench includ-
ed in the owner's tool kit.
6
1. Engine oil filler cap
2. Dipstick
3. Maximum level mark
4. Minimum level mark
5. Spark plug wrench
5. Wipe the dipstick clean, insert it
back into the oil filler hole (without
screwing it in), and then remove it
again to check the oil level.
NOTE:
The engine oil should be between the
minimum and maximum level marks.
6. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
7. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
6-16
cap with the spark plug wrench.
8. Install the engine oil filler cap cover
by placing it in its original position.
9. Place the floorboard mat in the
original position.
To change the engine oil (with or
without oil filter element replace-
ment)
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and the engine oil drain bolt to
drain the oil from the crankcase.
1. Engine oil drain bolt