01 Safety; Seatbelts - Volvo S80 Owner's Manual

01 Safety

Seatbelts

01
General information
Heavy braking can have serious consequences
if the seatbelts are not used. Ensure that all
passengers use their seatbelts.
It is important that the seatbelt lies against the
body so it can provide maximum protection.
Do not lean the backrest too far back. The
seatbelt is designed to protect in a normal
seating position.
Putting on a seatbelt
Pull the seatbelt out slowly and secure it by
pressing the buckle into the lock. A loud "click"
indicates that the seatbelt has locked.
The buckles only fit the intended lock in the rear
seat*.
*
14
Option/accessory, for more information, see Introduction.
Releasing the seatbelt
Press the red lock button and then let the seat-
belt retract. If the seatbelt does not retract fully,
feed the seatbelt in by hand so that it does not
hang loose.
The seatbelt locks and cannot be withdrawn:
•
if it is pulled out too quickly.
•
during braking and acceleration.
•
if the car leans heavily.
Keep in mind the following:
•
do not use clips or anything else that can
prevent the seatbelt from fitting properly.
•
ensure that the seatbelt is not twisted or
caught on anything.
•
the hip strap must be positioned low down
(not over the abdomen).
•
tension the hip strap over the lap by pulling
the diagonal shoulder belt as in the pre-
ceding illustration.
WARNING
The seatbelts and airbags interact. If a seat-
belt is not used or is used incorrectly, this
may diminish the protection provided by the
airbag in the event of a collision.
WARNING
Each seatbelt is designed for only one per-
son.
WARNING
Never modify or repair the seatbelts your-
self. Contact an authorised Volvo work-
shop.
If a seatbelt has been subjected to a major
load, such as in conjunction with a collision,
the entire seatbelt must be replaced. Some
of the protective characteristics of the seat-
belt may have been lost, even if it appears
to be undamaged. In addition, replace the
seatbelt if the belt is worn or damaged. The
new seatbelt must be type-approved and
intended for installation in the same position
as the replaced seatbelt.