Sony BRC-300 Specifications page 5

C2N-CAMIDJ_Speed_Adjust
Tilt_Up/Down
Pan_Left/Right
Zoom_In/Out
Focus_Near/Far
Auto_Focus_On/Off/Toggle
Preset_*
Save
Home
Power_On/Off
Track_Commands
Enable_Proportional_Pan_Tilt
Set_Addresses
White_Balance_Auto/Indoor/Outdoor/
OnePush/Manual/OnePushTrigger
Red_Gain_Up/Down/Reset
Blue_Gain_Up/Down/Reset
Auto_Exposure_Auto/Manual/Shutter
Priority/Iris_Priority/Bright
Shutter_Up/Down/Reset
Iris_Up/Down/Reset
Gain_Up/Down/Reset
A Analog signal connected to the SpeedAdjust output of the C2N-CAMIDJ
D Press and hold to tilt the camera.
D Press and hold to pan the camera.
D Press and hold to zoom the camera.
Press and hold to focus the camera. This will focus the camera if the
D
camera is not in auto focus mode.
D Pulse to turn the auto focus function on and off.
Pulse to go to the preset. If pulsed when the Preset_Save_Fb output is
D
high, this will store the current camera position in the selected preset.
D Pulse to put the module into save mode to allow storage of presets.
D Pulse to send the camera to the home position for pan and tilt.
D Pulse to turn the camera on and off.
D Pulse to activate and control the auto-tracking features of the camera.
Hold high to use proportional pan and tilt speeds. Hold low to use the auto
D
speed change feature of the module.
Pulse once to set the addresses for the cameras with the VISCA inputs
D
daisy chained.
D Pulse to select the desired White Balance mode
D Pulse to control the red gain level
D Pulse to control the blue gain level
D Pulse to select the desired exposure mode
D Pulse to adjust the shutter speed
D Pulse to adjust the Iris
D Pulse to adjust the gain