Front-Panel Displays - Pioneer DVR-550H-S Operating Instruction

Additional information
Message
• There is no DV input or the input
signal is unrecordable.
• No DV camcorder connected.
• You cannot connect more than one
DV camcorder at a time.
• Cannot operate the DV camcorder.
• Could not operate the DV camcorder.
• The DV camcorder is not set for
playback. Please select playback mode
on the DV camcorder.

Front-panel displays

The table below shows a list of error messages that you may encounter when using the
recorder and an explanation of their meaning.
Message
• E01
• E02
HDCP ERR
Explanation/Action
No signal was detected at the DV IN jack. This may
appear if a blank section of DV tape is playing in
the connected camcorder.
The camcorder is not connected properly, or the
camcorder is switched off.
This recorder's DV jack supports connection to
just one camcorder.
This recorder cannot operate the DV camcorder.
Try switching off the camcorder then turn it back
on again.
This recorder was not able to operate the DV
camcorder.
The camcorder is in camera mode. Switch it to
playback mode.
Explanation/Action
The HDD may be damaged or broken. Please ask
your nearest Pioneer-authorized service center or
your dealer to carry out repairs.
As the HDD info cannot be properly read, no new
recordings can be made. Reinitializing the HDD
(page 109) may result in your being able to make
recording again. Note that reinitializing the HDD
will erase all recorded contents, including
protected files.
Displayed when a device that is not HDCP-
compatible is connected to the HDMI terminal.
Connect a device that is HDCP-compatible.
16
135
En