Replacing The Rear Fan Assembly - Lenovo ThinkCentre 3029 User Manual

Replacing the rear fan assembly

Attention
Do not open your computer or attempt any repair before reading and
understanding the "Important safety information" in the ThinkCentre Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the rear fan assembly.
To replace the rear fan assembly, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 14.
3. Locate the rear fan assembly. See "Locating components" on page 10.
4. Disconnect the rear fan assembly cable from the system fan connector on the
system board. See "Locating parts on the system board" on page 11.
5. The rear fan assembly is attached to the chassis by four rubber mounts.
Remove the rear fan assembly by breaking or cutting the rubber mounts and
gently pulling the rear fan assembly out of the chassis.
Figure 30. Removing the rear fan assembly
6. Install the new rear fan assembly by aligning the new rubber mounts with the
corresponding holes in the chassis and push the rubber mounts through the
holes.
Note: The new rear fan assembly you received will have four new rubber
mounts attached.
Chapter 2. Installing or replacing hardware
37