Amana Bottom Freezer Refrigerator Owner's Manual page 6

5/16" screws
Top hinge
Door closure
(some models)
5/16"
hex nut
Center hinge
Phillips screws
Plug
(some models)
Bottom hinge
3/8"
screws
CAUTION
Protect soft vinyl or other flooring with cardboard, rugs
or other protective material to avoid property damage.
9. Reverse doors as necessary by performing the
following steps:
• Remove button plugs from opposite side of
refrigerator cabinet using putty knife covered with
masking tape. Insert button plugs in holes left from
hinge removal.
• Remove freezer door internal support rod located
underneath freezer handle. Reinstall internal
support rod in hinge hole on opposite side of door.
Support
rod
10. Rehang doors by replacing bottom, center, and top
hinges, along with freezer and refrigerator doors on
opposite side of refrigerator performing steps 2-8 in
reverse order.
• Use a penny at top to space door
• Handle side of door should be approximately
Center hinge
pin
Center hinge
bracket
Door closure
(some models)
11. Replace freezer door handles.
Models with freezer handle cap.
• Mount handle to opposite side of door using
• Angle front edge of handle cap downward toward
Models without freezer handle cap.
• Place hinge shim on non-hinge side of door. Large
6
from cabinet.
1 / " (3 mm) higher than hinge side.
8
3 / "
4
(18 mm)
mounting screws removed in previous step.
back lip of freezer handle. Verify bottom tab on
freezer cap slides under rear lip of freezer handle.
Snap rear edge of handle cap in place. Place 2
button plugs in empty mounting holes.
Freezer
handle
hole in hinge shim must line up with hole created
from hinge reversal.
3
/ " (18 mm)
4
1 / "
8
(3 mm)
Handle
cap
Screws
Freezer handle
shim
Hinge hole