GE 113D5497P183 Use And Care Manual page 25

PROBLEM
WATER WON'T
DRAIN
WATER LEAKS
WASHER IS NOISY
WASHER PAUSES
IN CYCLE
POSSIBLE CAUSE AND REMEDY
c Make sure drain hose is not kinked.
Top of drain outlet should be less than 8 ft. above floor.
Make sure hose connections are tight at faucets.
Make sure end of drain hose is correctly inserted in and secured to drain facility.
Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Installation Instructions.
A sharp distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission "locks in? This sound is normal.
Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases, (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary) the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, open the lid and redistribute the load evenly about the wash basket. Close
the lid and restart.
Washer normally pauses between washing steps. . .such as between wash and spin or
between spin and rinse.
If you need more help.. .cail, toll free:
GE Answer Center@
800.6262000
consumer information service
25
..-—. -----