Care And Cleaning - Sunbeam Dehumidifiers User Manual

OPERATION INSTRUCTIONS (cont'd)
WATER TANK:
• Water will drain into the tank. When the tank is full and the dehumidifi er stops operating, the
FULL indicator light will fl ash.
• Do not remove the water tank while the dehumidifi er is still working or has just stopped. This
might cause water to drip.
• To empty the water tank, remove the tank as shown below, empty the water, and replace.
• The dehumidifi er will restart when the water tank in back in the correct position.
1. Pull out the bucket.
2. Hold the two sides of the bucket and
with even strength, pull it out from
the dehumidifi er.
3. Pour out the water.
CONTINUOUS DRAIN:
If a drain is located near where you position your dehumidifi er, a hose can be connected for continuous
draining:
• When using continuous draining, remove the rubber plug very carefully from the back drain hole
and store it in a safe place so it does not get lost.
• Remove the water tank fi rst, then attach the hose onto the connector located inside the dehumidifi er.
• The hose should go down smoothly without bends or kinks.
• Place the end of the hose into a suitable drainage facility.
• When the continuous drain feature is not being used, remove the drain hose from the connector and
plug the rubber plug back into the hole.

CARE AND CLEANING

IMPORTANT:
• Be sure to unplug the dehumidifi er before cleaning.
• Do not use chemical agents to clean the dehumidifi er, as they may cause damage.
• Do not wash the dehumidifi er directly under a tap or hose. The electrical components inside may be
damaged.
WATER TANK:
• Wash the tank using warm water with a neutral detergent. Rinse and allow to dry. Replace tank
when dry.
1
6
2 3