McAfee IIP-S14C-NA-100I - IntruShield 1400 Sensor Appliance Product Manual page 19

McAfee® IntruShield® IPS 4.1
IntruShield Sensor 1400 Product Guide
2
3
Figure 1: Attaching the mounting ears to the sensor chassis
Mounting the I-1400 sensor in a rack
McAfee recommends rack-mounting your sensors. The rack-mounting hardware
included with the sensors is suitable for most 19-inch equipment racks and telco-type
racks. For maintenance purposes, you should have access to the front and rear of the
sensor.
Note:
Remove the power cable and all network interface cables from the sensor.
Rack-mount the sensor by securing the rack mount ears to two posts or mounting
strips in the rack. The ears secure the sensor to two rack posts, and the rest of the
sensor is cantilevered off the ears.
Note:
sensor and one person to secure it to the rack.
Mount the sensor by securing the ears to two posts or mounting strips in the rack.
Because the ears bear the weight of the entire sensor, be sure to fasten the ears
securely to the rack.
Attach the first chassis ear to the right side of the chassis. Use a Phillips
screwdriver to secure the Phillips flathead screws to the chassis.
Repeat this procedure for the other ear.
Before you mount the sensor in the rack, make sure that power is OFF.
You need two people to install the sensor in the rack—one person to hold the
Setting up the I-1400 sensor prior to configuration
11
Positioning the I-1400