GE Simon XT User Manual page 5

v
ACTA Part 68
This equipment complies with Part 68 of the FCC Rules. Located on this equipment is a label that
contains, among other information, the FCC registration number and the ringer equivalence
number (REN) for this equipment. If requested, this information must be provided to the
telephone company.
FCC Part 68 Registration No. US:B4ZAL02B55910
The REN is used to determine the maximum number of devices that may be connected to your
telephone line. Excessive RENs on a telephone line may result in devices not ringing in response
to an incoming call. In most areas, the sum of all device RENs should not exceed five (5.0). To be
certain of the number of devices that may be connected to a line, as determined by the total
RENs, contact the local telephone company. For products approved after July 23, 2001, the REN
for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The
digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier
products, the REN is separately shown on the label.
A plug and jack used to connect this equipment to the premises wiring and telephone network
must comply with the applicable FCC Part 68 rules and requirements as adopted by ACTA. A
compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compliant modular jack that is also compliant. See the Installation Instructions
for details.
Alarm dialing equipment must be able to seize the telephone line and place a call in an
emergency situation. It must be able to do this even if other equipment (telephone, answering
system, computer modem, etc.) already has the telephone line in use. To do so, alarm dialing
equipment must be connected to a properly installed RJ31X jack that is electrically in series and
ahead of all other equipment attached to the same telephone line. If you have any questions
concerning these instructions, consult your local telephone company or a qualified installer
about installing an RJ31X jack and alarm dialing equipment for you.
If this equipment causes harm to the telephone network, the telephone company may
temporarily disconnect your service. If possible, you will be notified in advance. When advance
notice is not practical, you will be notified as soon as possible. You will also be advised of your
right to file a complaint with the FCC.
The telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the operation of the equipment. You will be given advance notice
in order to maintain uninterrupted service.
If you experience trouble with this equipment, please contact the company that installed the
equipment for service and/or repair information. The telephone company may ask you to
disconnect this equipment from the network until the problem has been corrected or you are
sure that the equipment is not malfunctioning.
This equipment may not be used on coin service provided by the telephone company.
Connection to party lines is subject to state tariffs.