Yaesu FT-712RH Operating Manual page 36

Func. Name
Reset
Check Empty
Record All
Record One
Bit Rate
Confirm
Lock Last
Play All
Play One
Unlock All
Unlock One
Notes:
(1) High/low tone response indicates success (memory available or lock/unlock
executed), else low/high tone response indicates failure (memory full or
lock/unlock not executed).
(2) Calisign played back followed by a single beep if record successful, else
low/high tones returned after callsign playback (to indicate record attempt
failed).
(3) Same as Note (2) if command accepted, else no response.
(4) Callsign played back followed by a single beep and then the selected
segment(s), if successful. Low/high tones if playback command rejected. In
the case of multiple segments, each is separated by (suppressed) high/low
beeps.
Whenever a remote command is received, the transceiver display shows the
Segmentation Code accessed (0, or 2 - 8). Up to four Codes will be displayed,
scrolling in from the right on a first-in/first-out basis (older Codes disappear).
This allows you to tell at a glance if someone has called, and where their
messages may be located.
REMOTE
DTMF Code
### Cancel input or stop recording
#00 Check for unused segment(s)
*00 Record segments 2 through 8
*01 Record in any (unlocked) segment
* it
#01 Playback last recording to confirm
*02 Lock last recording
#10 Playback all unlocked segments
#lx Playback segment x (1 - 8 only)
#20 Unlock all locked segments
#2x Unlock segment x (1 - 8 only)
- 34 -
Description
Set Bit Rate r (l - 4) for recording
Note
(1)
(2)
(3)
(2)
(4)
(1)
(4)
(4)
(1)
(1)