Table of Contents
Advertisement
(3) Connect the 8-pin plug from the DVS-I to 8-pin jack J2003 on the inside
of the front panel (the gray wire should be nearest the center). See Figure
3.
(4) Connect the 7-pin plug from the DVS-I to 7-pin jack J2004 on the inside
of the front panel (the brown wire should be nearest the center).
(5) Connect the 3-pin plug from the DVS-1 to jack J1003 in the right front
corner of the speaker compartment.
(6) Making sure that no wires are pinched, set the DVS-I in place, routing
the speaker wires out under the back of the DVS-I. Install the two
supplied screws through the tabs in the DVS-I: one in the left front
corner of the chassis, and one in the rear.
(7) Set the Voice Memory Backup switch in the left rear corner of the DVS-I
(Figure 4) to the ON position (toward the rear).
(8) If also installing the FTS-12, proceed to step 2 of the FTS-12 Installation.
Otherwise, do step 5 of the FTS-12 Installation.
- 14 -
Hide quick links:
Advertisement
Table of Contents
