Configuration Using The Touch Controller - Cisco Codec C Series Getting Started Manual

Cisco TelePresence Video Systems
Contents

Configuration using the Touch controller

Waking up the system
If no menu is displayed on the Touch controller, tap the display
to wake up the system.
If the system does not wake up:
• Make sure the Touch controller is connected to the main unit.
• Make sure the main unit is connected to power and
switched on.
If the system has just been switched on, wait a few minutes to
allow the system to start up.
If in doubt, read the installation guide for your product.
Back to task overview
D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.
Introduction User interfaces Confirguration Configuration
Touch controller
12
Getting Started Guide
Appendices Contacts
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.