Foxconn H61MD Series User Manual page 23

HARDWARE INSTALLATION
Serial ATA Connectors: SATA_1/2/3/4
The Serial ATA connector is used to connect with
SATA Hard Disk or CD devices which support this
feature. The SATA_1/2/3/4 allows up to 3GB/s
data transfer rate.
fan Headers: CPU_fAN, SYS_fAN
The fan speed can be controlled and monitored
in the BIOS Setup. These fans can be automati-
cally turned off after the system enters S3, S4
and S5 sleeping states.
Chassis Intrusion Alarm Header : INTR
The connector can be connected to a security
switch on the chassis. The system can detect
the chassis intrusion through the function of this
connector. If eventually the chassis is closed, the
system will send a message out.
USb 2.0 Headers: f_USb1/2
These connectors comply with USB 2.0 specifi-
cation, you can get USB ports by connecting the
USB module cable to any of these connectors.
16
GND
1
POWER
SENSE
CONTROL
CPU_FAN/SYS_FAN
1
INTRUDERJ
GND
INTR
1
GND
TX+
TX-
GND
RX-
RX+
GND
SATA_1/2/3/4
1 2
VCC VCC
D- D-
D+ D+
GND GND
EMPTY NC
9 10
F_USB1/2