Fox Intelligent Stepping - Foxconn A85GM Series User Manual

► Smart Power LED
Smart Power LED is a feature built on your motherboard to indicate different states during
Power On System Test (POST). The LED is located at the front panel, and it displays POST
state by different long-short blinking intervals. You can always leave this state enabled.
System Status
Normal
No Memory
No VGA Card detec
Post Error Message
No CPU Fan
► Smart Boot Menu
When PC starts, it will ask you to press [Del] key to enter setup or press [Esc] key to enter
smart boot menu. If [Disabled] is selected, then pressing [Esc] has no function.
► Current CPU Speed
This item displays the current CPU speed.
► Current FSB Multiplier
This item displays the current FSB Ratio.
► Current DRAM Speed
This item displays the current DRAM speed, in dual channels.

Fox Intelligent Stepping

CPU Clock
Memory Speed Mode
GFX Engine Clock Override
PCI Express Clock
CPU Multiplier Adjust
Spread Spectrum
CPU-NB HT Link Speed
NCHT Incoming Link Width
NCHT Outgoing Link Width
► CPU Clock
This option is used to adjust the CPU clock.
► Memory Speed Mode
This item is used to enable/disable provision of DRAM timing by SPD device. The SerialPres-
ence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memorymodule. It
Power LED Status
Always On
Continue blinking On (1sec.), Off (1sec.)
Continue blinking On (2sec.), Off (2sec.)
Quick blinking twice (1/3sec. On, 1/3sec. Off),
one long On (1sec.), continuously.
Continue blinking On (1/2sec.), Off (1/2sec.)
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
Fox Intelligent Stepping
↑↓←→:Move Enter:Select
F1:General Help
[200] 200
[Auto]
[Disabled]
[100]
[Auto]
[Enabled]
[Auto]
[Auto]
[Auto]
+/-/:Value F10:Save
F9:Optimized Defaults
26
Stop Blinking Condition
Always On
Reboot & Memory OK
Reboot & Display OK
Enter Setup or Skip
Reboot & Fan OK
Help Item
ESC:Exit