Table of Contents
Advertisement
Mobility
Then lay the cap on its upper side and close
it, refer to arrow.
6.
Position the cargo area lamp and clip it in,
refer to arrow.
License plate lamps
Follow the general instructions on lamps and
bulbs, refer to page 288.
These lamps are made using LED technology.
Contact your service center in the event of a
malfunction.
Center brake lamp
Follow the general instructions on lamps and
bulbs, refer to page 288.
This lamp uses LED technology for operation.
Contact your service center in the event of a
malfunction.
292
Replacing components
Online Edition for Part no. 01 40 2 901 869 - 03 12 500
BMW X6: bulb replacement
Xenon headlamps
Notes
Because of the long life of these bulbs, the like‐
lihood of failure is very low. Switching the lamps
on and off frequently shortens their life.
If a xenon bulb fails, switch on the front fog lamps
and continue the trip with great care. Comply
with local regulations.
Do not perform work/bulb replacement on
xenon headlamps
Have any work on the xenon lighting system, in‐
cluding bulb replacement, performed only by a
service center.
Due to the high voltage present in the system,
there is the danger of fatal injuries if work is car‐
ried out improperly.◀
Follow the general instructions on lamps and
bulbs, refer to page 288.
Parking lamps, roadside parking lamps,
daytime running lights
The illustration shows the left side of the engine
compartment.
35-watt bulb, H8
1.
Turn the cover to the left and remove.
2.
Left side of vehicle: rotate the bulb holder to
the right, see arrow, and remove.
Advertisement
Table of Contents
