Sharp MD-MT180 Service Manual page 18

MD-MT180
ATT Auto Adjustment
A U T O 2
A T 2
Normal end
A D J . O K
ENTER
PLAY
S Q # # # #
A P # # # #
* When the [STOP
* " " represent the adjustment number as follows.
0 0 : Innermost periphery move
0 3 : Pit section tracking ATT setting
0 4 : Pit section focus ATT setting
0 6 : External periphery move
0 7 : TCRS ATT setting
0 8 : Groove section tracking ATT setting
0 9 : Groove section focus ATT setting
Continuous Playback
• Continuous playback from current pickup position
• Continuous playback from any address
* When the [STOP
* In the start address set state the start address changes as follows when the [MENU] button is pressed.
0 0 3 2
A d 0 0 3 2
* In the start address setting state the start address change digit changes when the [ENTER] button is pressed.
1st digit (initial value)
A d 0 0 3 2
* In the start address set state the value of selection digit changes in the range of "0h to Fh"
when the [FAST FORWARD/REVERSE
* In the continuous playback state the number of jump lines changes as follows shown
the [BASS] button is pressed.
1 (initial value)
* When the [FAST FORWARD
number of lines occurs in the external periphery direction.
If the key is held down jump occurs continuously (100 ms cycle).
* When the [FAST REVERSE
specified number of lines occurs in the internal periphery direction.
If the key is held down, jump occurs continuously (100 ms cycle).
: ATT auto adjustment menu
PLAY
: During ATT auto adjustment
Adjustment error
A D J . N G
: ATT adjustment error (adjustment value output)
: ATT adjustment normal end (adjustment value output)
: Focus balance Adjustment mode
b # # #
: Continuous playback (high reflection)
: Continuous playback (low reflection)
] button is pressed in specific menu, the "TEST MODE STOP" state is set.
T P L A Y
: Continuous playback menu
PLAY
S Q # # # #
: Continuous playback (pit section)
: Continuous playback (groove section)
A P # # # #
# # # # : Address
T P L A Y
: Continuous playback menu
MENU
A d 0 0 3 2
: Start address setting
PLAY
S Q # # # # : Continuous playback (pit section)
: Continuous playback (groove section)
A P # # # #
# # # # : Address
] button is pressed in specific menu, the "TEST MODE STOP" state is set.
(initial value) 0 3 C 0
H H
MENU
A d 0 3 C 0
2nd digit
ENTER
A d 0 0 3 2
/
10
BASS
1 T R 1 0 T R
] button is pressed in the continued playback mode, jump of specified
] button is pressed in the continuous playback mode, jump of
: Focus balance
# # # : Jitter error
(low reflection only)
(low reflection only)
(low reflection only)
(low reflection only)
0 7 0 0
H
MENU MENU
A d 0 7 0 0
A d 0 9 5 0 H
0 9 5 0
H
3rd digit
ENTER
A d 0 0 3 2
ENTER
] button is pressed.
384
BASS
3 8 4 T R
BASS
– 18 –
0 8 A 0
H
A d 0 8 A 0
MENU