Table of Contents
Advertisement
3.
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G 1~8)
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you
can create a RAID 0, RAID 1, RAID 5, RAID 10 and JBOD configuration through the
onboard controller.
A88X-PLUS
A88X-PLUS AMD
•
•
•
1-16
SATA 6.0Gb/s connectors
®
These connectors are set to AHCI mode by default. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.6.2 SATA Configuration for details.
You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
XP SP3 or later version.
®
When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.6.2 SATA Configuration for details.
XP Service Pack 3 or later version before using Serial
®
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
