Piping And Drain Hose Installation - Toshiba Carrier RAS-09 Installation Manual

Split type

Hide thumbs Also See for Carrier RAS-09:

Owner's manual (4 pages)

Table Of Contents

Table of Contents

CAUTION

When installing the mounting plate with a mounting screw, do not use the

anchor bolt holes. Otherwise, the unit may fall down and result in personal

injury and property damage.

Installation plate

(Keep horizontal direction.)

3/16 in. (5 mm) dia. hole

Clip anchor

(ﬁ eld supplied parts)

CAUTION

Failure to ﬁ rmly install the unit may result in personal injury and property

damage if the unit falls.

• In case the unit is to be installed in a block, brick, concrete or similar type

walls, make 3/16 in. (5 mm) dia. holes in the wall.

• Insert clip anchors for appropriate mounting screws 7.

NOTE

• Secure four corners and lower parts of the mounting plate with 4 to 6

mounting screws to install it.

Wiring Connection

How to connect the connecting cable

1. Open the air inlet grille upward.

2. Remove the screws securing the front panel.

3. Slightly open the lower part of the front panel, then pull the upper part of

the front panel toward you to remove it from the rear plate.

4. Insert the conduit pipe (according to local codes) into the pipe hole on

the wall.

5. Remove the conduit mount by loosening the ﬁ xing screw (Fig. 1)

6. Fix conduit pipe to conduit mount with the lock nut.

7. Pull out the connecting wire through the conduit pipe and process the

wire. (Fig. 3)

8. Take out the wire to the front and ﬁ x it to the terminal block.

Be careful not to mis-wire. (Fig. 2)

9. Firmly tighten the terminal screws to prevent them from loosening.

Tightening torque: 0.9 lbf.ft (1.2 N·m). After tightening, pull the wires

lightly to conﬁ rm that they do not move.

10. Secure the connecting wire with the cord clamp.

11. Fix the conduit mount back to the body by ﬁ xing a screw.

12. Fix the front panel, terminal cover and air inlet grille to the indoor unit.

Air inlet grille

CAUTION

• Be sure to refer to the system wiring

diagram located inside the front panel.

• Check local electrical codes and also

any speciﬁ c wiring instructions or

limitations.

1110251291-1 EN.indd 9

Anchor bolt

Projection

9/16 in. (15 mm)

or less

Mounting screw

Ø5/32 in. × 1 in.

(Ø4 mm × 25 mm)

Front panel

Fig. 3

Ground

4-5/16 in. (110 mm)

line

13/16 in. (20 mm)

3/8 in. (10 mm)

3-5/32 in. (80 mm)

Fig. 1 Construction

Interconnecting

cable

Fixing screw

Fig. 2 Wiring

Cord clamp

Terminal cover

Screw

Front panel

NOTE

• Use stranded wire only.

• Wire type : minimum AWG14

How to install the air inlet grille on the indoor

unit

• When attaching the air inlet grille,

perform the same process as for

removal but in reverse order.