Making A Recording; Exchanging Sd Cards During Recording - Bosch CCS 900 Ultro Installation And Operating Manual

CCS 900 Ultro
7.4.2

Making a recording

Refer to figure 7.1.
Make a recording as follows:
1.
NOTICE!
If the unit has just been powered up, the record mode is automatically selected.
2.
3.
NOTICE!
The record feature supports a maximum of 999 recorded files.
7.4.3

Exchanging SD cards during recording

The SD card can be changed at any time during recording, but the new card must be inserted
within one minute of pressing the change card button (5). This allows discussion to continue
even when the SD card is full. If the new card is not inserted within 1 minute, the card missing
icon will be shown and recording will stop. The last minute of recorded discussion will also be
lost.
When there is 5 minutes of recording time left on the card, three short beeps will be played
through the monitor loudspeaker. This is to warn the operator to change the card. If the card
is not changed within 5 minutes, a long beep will be played through the monitor loudspeaker
at 0 minutes, and the card exchange function will automatically start.
NOTICE!
If a headphone is connected to the Control Unit, the beeps can only be heard via the
headphone, and the blue LED will flash quickly (5Hz).
Refer to figure 7.1.
Change the card as follows:
1.
2.
Bosch Security Systems B.V.
Press the change mode button to select the record mode. When selected, the record icon
is shown in the top right-hand corner of the display.
Press the record button (2) to start recording. The blue LED next to the SD card holder
will come on and the time counter will start.
During recording you can:
– press the pause button (2) to temporarily halt recording.
– press the stop button (3) to stop recording and close the recording session.
– press the new file button (4) to create a new file.
– change the SD card by pressing the change card button (5) on the display (see
section 7.4.3).
Remove the current card.
– When the card is removed, the recorder will continue recording to the internal buffer
of the recorder.
Insert the new card within one minute of pressing the change card button (5).
– When the new card is inserted, a new file is automatically started using the current
date and time as the file name. This file includes the previous 90 seconds of
discussion (60 seconds from the internal buffer and the last 30 seconds of
discussion from the previous card). This feature also allows transcription to take
place off-line before the meeting has ended.
Installation and Operating Manual
Built-in MP3 recorder (CCS-CURD only) | en
IOM_CCS900 | V1.0 | 2010.06
31