Multicast Forwarding - Address Translation - D-Link NetDefend DFL-210 User Manual

4.5.2. Multicast Forwarding using the
SAT Multiplex Rule
This scenario is based on the previous scenario but now we are going to translate the multicast
group. When the multicast streams 239.192.10.0/24 are forwarded through the if2 interface, the
multicast groups should be translated into 237.192.10.0/24. No address translation should be made
when forwarding through interface if1. The configuration of the corresponding IGMP rules can be
found below in Section 4.5.3.2, "IGMP Rules Configuration - Address Translation".
Example 4.9. Multicast Forwarding - Address Translation
The following SAT Multiplex rule needs to be configured to match the scenario described above:
Web Interface
A. Create a custom service for multicast called multicast_service:
1. Go to Objects > Services > Add > TCP/UDP
2. Now enter:
• Name: multicast_service
• Type: UDP
• Destination: 1234
B. Create an IP rule:
1. Go to Rules > IP Rules > Add > IP Rule
2. Under General enter.
• Name: a name for the rule, eg. Multicast_Multiplex
• Action: Multiplex SAT
• Service: multicast_service
3. Under Address Filter enter:
• Source Interface: wan
• Source Network: 192.168.10.1
Caution
As previously noted, remember to add an Allow rule matching the SAT Multiplex rule.
113
Chapter 4. Routing