Before Using Remote Control; Preparing The Remote Control Unit; Changing The Battery Of The Remote Control Unit - Kenwood KDC-X997 Instructions Manual

KDC-X997/KDC-BT955HD/KDC-X897/KDC-BT855U/KDC-X697/KDC-655U/KMR-555U
21. Basic operation of remote control (KDC-X997, KDC-BT955HD, KDC-X897, KDC-BT855U, KDC-X697, KDC-655U)

21-1. Before using remote control

21-1. Before using remote control

Preparing the remote control unit

Pull the battery sheet out from the remote control unit in the direction of the arrow.

Changing the battery of the remote control unit

Use a commercially available button battery (CR2025). Insert the battery with the + side facing upward,
following the illustration inside the case.
1. Keep on sliding.
2. Pull out.
! CAUTION
Keep battery out of reach of children and in original package until ready to use. Dispose of used
batteries promptly. If swallowed contact physician immediately.
Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat
generation may result.
Do not set the remote control in hot places such as on the dashboard.
The Lithium battery is in danger of explosion if replaced incorrectly. Replace only with the same
or equivalent type.