For Wired Network Interface Users (For Mac Os ® X 10.2.4 Or Greater) - Brother MFC-885CW Quick Setup Manual

Installing the Driver & Software
For Wired Network Interface Users
5
(For Mac OS
Important
Make sure that you have finished the
instructions from STEP 1 Setting Up the
Machine on pages 5 through 15.
Note
®
• For Mac OS X 10.2.0 to 10.2.3 users, upgrade to
®
Mac OS X 10.2.4 or greater. (For the latest
information for Mac OS
http://solutions.brother.com)
• Make sure there are no memory cards or a USB
Flash memory drive inserted into the media drives
or USB direct interface at the front of the machine.
1
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
2
Connect the network cable to the LAN socket
marked with a
LAN socket inside the machine on the left as
shown below.
®
X 10.2.4 or greater)
®
X, visit
symbol. You will find the
3
Carefully guide the network cable into the
trench as shown below, following the trench
around and toward the back of the machine.
Then, connect the cable to your network.
Improper Setup
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used, guide
both cables through the trench with one on top of
the other.
4
Lift the scanner cover to release the lock
Gently push the scanner cover support
down and close the scanner cover
Note
Make sure that the machine is turned on by
connecting the power cord.
®
Macintosh
.
.
41