Leveling; Door Alignment - Kenmore 795.6800 Series Use & Care Manual

LEVELING

To avoid vibration, the unit must be leveled. If necessary,
adjust the leveling legs to compensate for unevenness of
the floor. The front should be slightly higher than the rear
to aid in door closing.
Your refrigerator has two Front Leveling Screws - one on
the right and one on the left. If your refrigerator seems
unsteady or you want the doors to close more easily,
adjust the refrigerator's tilt using the instruction below:
1. Plug refrigerator power cord into a 3-prong grounded
outlet. Move the refrigerator into its final position.
2. Insert a flat screwdriver in slots to adjust the Leveling
Screws. Turn the leveling screw clockwise to raise the
side of the refrigerator or counterclockwise to lower
it. It may take several turns of the leveling screw to
adjust the tilt of the refrigerator.
NOTE: Having some push against the top of the
refrigerator takes some weight off of the leveling screws.
This make it easier to adjust the screws.
3. Open both doors again and check to make sure that
they close easily. If not, tilt the refrigerator slightly
more to the rear by turning both leveling screws
clockwise. It may take several more turns, and you
should turn both leveling screws the same amount.

DOOR ALIGNMENT

If the space between your doors is uneven, follow the
instructions below to align the doors.
1. Gently pry off the refrigerator door Top Hinge Cover
with a flat head screwdriver and remove. Loosen the
Top Hinge Bolts using a 10mm or
or open-end wrench.
2. Have a second person hold the refrigerator door in its
proper position.
3. Replace the Top Hinge Cover.
19
REFRIGERATOR INSTALLATION
Socket wrench
13
/ ''
32