Table of Contents
Advertisement
2
Terminal Interfaces
Keyboard Wedge Connection
3800/3900 scanners are factory programmed for a keyboard wedge interface to
an IBM PC AT with a USA keyboard. If this is your interface and you do not
need to modify the settings, skip to
Chapter 3
- Output.
If you programmed the scanner for a different terminal interface and/or you want
to change to an IBM PC AT and Compatibles Keyboard Wedge interface, scan
the barcode below.
IBM PC AT and Compatibles
with CR suffix
Terminal ID
If your interface is not a standard PC AT, refer to "Supported Terminals" on page
2-2 through
page
2-3, and locate the Terminal ID number for your PC. Scan the
Terminal ID barcode below, then scan the numeric barcode(s) on the inside
back cover of this manual to program the scanner for your terminal ID. Scan
Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID barcode, then 0, 0, 3 from the inside back cover, then Save. If you
make an error while scanning the digits (before scanning Save), scan the Dis-
card code on the back cover, scan the Terminal ID barcode, scan the digits,
and the Save code again.
Terminal ID
Save
Note: After scanning one of these codes, you must power cycle your computer.
2 - 1
Advertisement
Table of Contents
