Accessories - AquaStar 240 FX Installation And Owner's Manual

ACCESSORIES

Two 18" wide wall support brackets are
supplied with the 240FX water heater. Use for
wall mounting. Part number:
Remote temperature controller for Aquastar
240FX. The 240TSTAT is a remote control
thermostat that can increase or decrease the
output temperatures, turn the power to the
heater on and off and diagnose errors if there is
ever a failure. It connects to the heater, using
18GA thermostat wire, and can mount most
anywhere in the home, 100 feet max. from the
heater. The 18 gauge wire is not supplied with
the 240TSTAT. Part number:
For up to an 8 inch thick wall
TEMPLATE 10-1/8"x10-1/8"
240BRACKET
240TSTAT
10-1/8"
10-1/8"
16
ACCESSORIES CAN
THROUGH YOUR
CONTROLLED ENERGY.
Back draft prevention vent terminator for
horizontally vented installations. Prevents cold
air from blowing into the heat exchanger and
harming the unit. Part number:
See installation template below.
Sample of the FXHOOD
mounting template that is
supplied with the FXHOOD
sidewall vent terminator. The
inside vent pipe connection is 4"
diameter. There is a larger
circular pipe around the inner 4"
pipe that maintains clearance.
Additionally there are four tabs
around the outer pipe that
maintain proper clearance to
combustibles once installed.
These tabs require the installation
hole to be square. Rough opening
is (10 1/8" x 10 1/8").
BE ORDERED
DEALER OR
FXHOOD