Robitussin DH-832 Series Owner's Manual page 4

NOTE: We recommend that the humidifier be disinfected prior to first use. Please
see CLEANING instructions.
• Select a firm, level, flat location - at least six inches (15 cm) from any wall for
proper air flow (Fig. 1). Place the humidifier on a water-resistant surface, as
water can damage furniture and some flooring.
The manufacturer will not accept responsibility for property damage caused by
water spillage.
• Remove the water tank by grasping handle and
pulling straight up. Set aside (Fig. 1).
• Remove the Natural Cool Moisture™ filter from the
base before filling the unit with water (Fig. 2). Soak
filter in a sink full of cool water to help reduce min-
eral build up and place back in the humidifier while
wet. DO NOT SQUEEZEORWRING OUT THE NATUR-
AL COOLMOISTURE™ FILTER. To help extend the
life of your filter repeat this step each time you fill
your humidifier.
• Turn the Water Tank upside down so that the Fill Cap
is facing up; unscrew the Fill Cap by turning it
counter-clockwise
• Fill the Water Tank with COOL tap water (Fig. 3).
Distilled water is not necessary as the water is filtered
by the Natural Cool Moisture™ filter. DO NOT USE HOT
WAT E R . Doing so may damage the humidifier.
• Replace the fill cap by turning it clockwise
DO NOTOVER TIGHTEN. Turn the Water Tank right-
side up.
NOTE: WHEN CARRYING THE FILLED WATER TANK
PLEASE USE THE HANDLE AND PLACE YOUR OTHER
HAND UNDER THE TANK FOR ADDITIONAL SUPPORT.
and set aside.
Fig. 1
Fig. 2
.
Fig. 3
SET UP
FILLING