Troy-Bilt TB350 Operation Manual page 23

Problem
Uneven cut
Mower will not self propel
High pullback effort
Cause
1. Wheels not positioned correctly.
2. Dull blade.
1. Belt not installed properly.
2. Debris clogging drive operation.
3. Damaged or worn belt.
4. Drive control out of adjustment.
1. Pulling mower backwards before
transmission disengages.
Remedy
1. Place front and rear wheels in same height
position. (Dual Height Adjusters)
2. Sharpen or replace blade.
1. Check belt for proper pulley installation and
movement.
2. Stop engine, disconnect spark plug boot,
and clean out debris.
3. Inspect and replace belt.
4. Adjust drive control. (See Assembly & Set-up
section).
1. Allow the unit to roll forward slightly without
the drive lever(s) engaged before pulling
backwards.
S 8 — t
ection roubleShooting
23