Replacing the light bulbs: 322T AWD
For information about the bulb type, see Technical Data.
1 Unscrew the two screws holding the cover on the power
servo housing. One screw on each side.
2 Disconnect the cables from the bulbs.
3 Gently push in the locking mechanism and fold out the
lamps from their brackets.
4 Insert the new lamps in the lower slot on the lamp
housing.
5 Press the lamp in place in the locking bracket
6 Fit the lamp holder in the lower slots on the servo housing.
26 –
English
Maintenance
7 Refit the cables and screw the lamp holder on to the servo
housing.
Main fuse
The main fuse is placed in a detachable holder under the
battery case's cover, in front of the battery.
Type: Flat pin, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round.
To improve driving the pressure on the rear tyres can be
reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
IMPORTANT INFORMATION
Having the same air pressure in the tyres is important in
order to achieve the best possible performance as well as
to avoid damage to the machine