GE Profile 200D2600P039 Owners And Installation Manual page 25

4 DISCONNECT THE POWER
COUPLING (on some models)
If the refrigerator has a water dispenser,
there is a power line (harness) from the
cabinet into the bottom hinge on the
freezer door that must be disconnected.
To disconnect, pull apart at the coupling.
Bottom
freezer
hinge
DISCONNECT THE ELECTRICAL
5
CONNECTORS (on some models)
If the refrigerator has a refreshment
center, there are electrical connectors
(harnesses) from the cabinet into the
bottom hinge on the refrigerator door
that must be disconnected.
To disconnect, pull apart each connector.
Installation Instructions
Bottom
refrigerator
hinge
25
6 CLOSE THE FREEZER AND
REFRIGERATOR DOORS
REMOVE THE FREEZER DOOR
7
Remove the freezer door top hinge cover
A
(if equipped) by either squeezing it and
pulling it up or by prying it off with a
plastic putty knife.
B Remove the two 5/16" or 1/8" hex head
screws, then lift the hinge straight up to
free the hinge pin.
5/16" or 1/8" hex head
C Open the freezer door to 90.°
90°