Using The Lsi Logic Configuration Utility Program; Starting The Lsi Logic Configuration Utility Program - IBM System x3250 User Manual

To clear CMOS and reset the passwords, complete the following steps.
Note: All configuration settings will be cleared by this action; you might have to
configure the settings again.
1. Review the safety information that begins on page v.
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the server from the rack and place it on a flat, static-protective surface.
4. Remove the cover. See "Removing the cover" on page 18 for instructions.
5. Remove the riser-card assembly. See "Installing an adapter" on page 19 for
6. Move the clear-CMOS jumper from pins 1 and 2 to pins 2 and 3 and leave it
7. Reinstall the riser-card assembly and cover.
8. Replace the server in the rack and connect the server to a keyboard, monitor,
9. Turn on the server. You can now start the Configuration/Setup Utility program

Using the LSI Logic Configuration Utility program

Use the LSI Logic Configuration Utility program to configure hot-swap hard disk
drives that are connected to the SAS/SATA controller.
Important: If the server is a simple-swap SATA model and you have installed an
optional SATA RAID Kit, you can use the LSI Logic Configuration Utility program to
configure the simple-swap SATA hard disk drives.
v If the server is a simple-swap SATA model and you have installed an optional
v If you install an optional RAID controller in the server, such as the ServeRAID 8s

Starting the LSI Logic Configuration Utility program

To start the LSI Logic Configuration Utility program, complete the following steps:
1. Turn on the server.
2. When the prompt Press CTRL-C to start LSI Logic Configuration Utility...
3. Use the arrow keys to select the adapter (SAS controller) for which you want to
4. To change the settings of the selected items, follow the instructions on the
5. Press Enter to save your changes.
external cables.
instructions.
there for at least 5 seconds; then, move the clear-CMOS jumper back to pins 1
and 2.
and mouse; then, connect the server to a power source.
and either delete the old password or set a new power-on or administrator
password.
SATA RAID Kit, you can use the LSI Logic Configuration Utility program to
configure the simple-swap SATA hard disk drives.
controller, use the configuration software that comes with the adapter to configure
the hard disk drives.
is displayed, press Ctrl+C. If you have set an administrator password, you are
prompted to type the password.
change settings. Use the Help function to see instructions and available actions
for this screen.
screen.
Chapter 3. Configuring the server
43