Yamaha VINO 125 Owner's Manual page 46

PERIODIC MAINTENANCE AND MINOR REPAIR
2
1
3
2
1
3
ZAUM00**
4
1. Engine oil level check window
2. Maximum level mark
3. Minimum level mark
5
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
6
of the recommended type to raise
it to the correct level.
7
To change the engine oil and clean
8
the oil strainer
1. Start the engine, warm it up for sev-
eral minutes, and then turn it off.
9
2. Place an oil pan under the engine
to collect the used oil.
3. Remove panel A. (See page 6-8.)
4. Remove the engine oil filler cap and
drain bolts to drain the oil from the
crankcase.
1
ZAUM00**
1. Engine oil filler cap
1
ZAUM00**
1. Engine oil drain bolt A
cC
When removing the engine oil drain
bolt, the O-ring, spring, and oil
strainer will fall out. Take care not to
lose these parts.
6-10
5. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
4 3 2
ZAUM00**
1. Engine oil drain bolt B
2. O-ring
3. Compression spring
4. Strainer
6. Check the O-ring for damage and
replace it if necessary.
7. Install the oil strainer, spring, O-ring
and engine oil drain bolts, and then
tighten the drain bolts to the speci-
ECA10410
fied torque.
1
1